Quick steps (visitor-friendly)
- Close windows in the room (otherwise you’re drying the outdoors).
- Set target humidity to 45–50%.
- Place it correctly: leave a few inches of space around air intake/exhaust.
- Run 2–6 hours, then reassess the smell/comfort.
- Empty the tank when the FULL light turns on (or it shuts off).
Where to place it (best results)
- Bathroom after showers (door mostly closed).
- Laundry area if you’re air-drying clothes.
- Basement/ground-level rooms that feel damp.
If it won’t start (common simple causes)
- Tank not seated: push it in fully.
- FULL light: empty and reinsert the tank.
- Filter clogged: if there’s an easy-access filter, it may need a quick clean.
- Delay/protection timer: some units wait a few minutes after power loss.
Direct booking makes “apartment comfort” support easier
If humidity or musty smells are bothering you, fast guidance helps. Direct booking keeps support straightforward and responsive.
FAQ
What humidity setting should I use?
For most apartments, 45–50% is a good comfort target that also reduces musty smells.
Should I run it with windows open?
No—close windows/doors in the room, otherwise you’re trying to dehumidify outside air.
Why does it stop and show FULL?
The water tank is full (or not seated). Empty it, reinsert it fully, and restart.